Learning About How Your Dish Washer Work
All washing machines have the same components: a watertight container called the tub, a drum which fits inside the tub to store the washing electronic valves that allow water into the tub; heating elements to raise the water temperature and an electric motor that is used to turn the drum; an emptying pump for the water and a controller to manage the switching of all the parts. It's easier to repair and maintain your washing machine once you are aware of how each part works.
How a programmer works
The programmer acts as the brain of the washing machine. When you have selected the settings you wish to use for the type of fabric that you want to wash The programmer will take over. In case where you really need to discover extra information on washing machine, you have to sneak a peek at https://www.ziemellatvija.lv/reklamraksti/velas-masina-vienam-cilvekam-ka-izdarit-izveli-157109 website.
Every program is a combination of the same elements including the amount of water taken in via the inlet valves (which dictates how far the clothes fall after they fall off the top of the drum--and that's how hard they impact the water) The temperature of the water as well as the detergent solution; how long the drum rotates in the spin and wash sequences and how fast it turns.
Programmer also controls operation of drain pump at various points in the washing cycle.
What happens during a wash cycle
Setting the programme controller and turning on the machine activates the door interlock Once the door is shut it is not able to be opened until the programme is finished.
The program starts as soon as the door has been closed. The inlet valves are opened, allowing water to flow through the drum. As it flows, it goes through the tray of detergent either powder for collection or liquid.
The water in the drum is compressed by air within a pressure chamber. this pressure is relayed along a flexible pressure tube to a switch for pressure, that switches the valves inlet at the programmed water level.
The heating element turns on raising the water temperature to the pre-programmed temperature. in very hot washes only the valve for hot water inlet may be opened. This will reduce the duration the heating element remains in operation.
The motor is turned on and the drum is driven at a speed of around 55rpm. This speed is ideal for washing clothes. They stay on the drum until the point at which they stop each revolution, then they fall into the solution of detergent.
The motor must be shut off and the pump switched on to flush the dirty water from the tub using either a lint-filter or drain hose. The cold inlet valve can be opened after an intense wash to cool the fabrics and shield them from damage.
To begin the rinse cycle to begin the rinse cycle, shut off the pump and open the cold valve. The cycle repeats, with the tub filling to the pre-programmed level The drum is rotating, and the water being expelled.
At the end of the final rinse then the spin cycle kicks off. The motor is switched on, revolving the drum at a high speed. The pump is switched on to remove the water coming from the clothing.
The motor of your own washing machine is switched off. After a delay for the drum to stop spinning, the door lock can be disengaged. After that, the program is completed and the door is able to be opened.